rollers along the conveyor until the press stops. The pull force difference during this process cannot be more than 2%. If this ratio is not adjusted well, the scrap aluminum ratio may increase. The profiles, whose pulling process is completed, are taken on the conveyor with the transfer belts on the rollers.
Various pulling systems are available as follows;
- Single puller
- Double Puller
- Twin-Twin puller unit
- Three head puller unit
Puller units grip the aluminum profiles as they exit the extrusion press and perform the pulling operation over the conveyor rollers until the press stops. The difference in pulling force must not exceed a maximum of 2%. If this ratio is not properly adjusted, the scrap aluminum rate may increase.
After the pulling process is completed, the profiles are transferred from the rollers onto the conveyor by transfer arms.
Various pulling systems are available, as shown below.
- Single puller
- Double Puller
- Twin-Twin puller unit
- Three head puller unit
Contact Us
